From log to finished panel: the seven general steps of plywood manufacturing, from peeling and drying to pressing and sanding.
From log to veneer
Plywood starts as logs. They are debarked and cut to size before peeling. A log is then rotated against a sharp blade that peels off a continuous sheet of thin wood called veneer.
The wet veneer is dried until it reaches a set moisture level. Drying matters: it lets the glue bond properly and helps the panel stay flat instead of warping or coming apart later.
Building the panel
Glue is spread on the veneers, and they are stacked with the grain direction alternating from one layer to the next. This cross-layering is what gives plywood its stability and strength.
The stack goes through a pre-press stage and then a hot press, where heat and pressure cure the glue and bond the layers into one solid panel.
Finishing
The pressed panel is trimmed to its final size and sanded smooth. Sanding is finer for higher grades, and panels may get a face veneer or a laminate or UV finish.
The exact process differs from one factory to another and with the wood species and the product being made.